LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Link Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Stabilizer Shaft And Link
    GM236116Courtesy of GENERAL MOTORS CORP.
  1. Install the stabilizer shaft link (1) to the vehicle.
  2. Connect the stabilizer shaft link (1) to the stabilizer shaft (2).
    3. NOTE: Refer to Fastener Notice .
  3. Install the stabilizer shaft link nut to the stabilizer shaft link (1) and the stabilizer shaft (2).

    Tighten:  Tighten the nut to 50 N.m (37 lb ft).

    4. Fig 2: View Of Stabilizer Shaft Link
    GM614968Courtesy of GENERAL MOTORS CORP.
  4. Connect the stabilizer shaft link (2) to the strut.
  5. Install the stabilizer shaft link nut (1) to the stabilizer shaft link (2) and the strut.

    Tighten:  Tighten the nut to 52 N.m (38 lb ft).

  6. Lower the vehicle.
scientia non olet · About LEMON Manuals