LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Insulator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Stabilizer Shaft Insulator
    GM1209606Courtesy of GENERAL MOTORS CORP.
  1. Install the stabilizer shaft insulator (2) to the stabilizer shaft.
    2. NOTE: Refer to Fastener Notice .
  2. Install the stabilizer shaft insulator bracket.

    Tighten:  Tighten the bolt to 48 N.m (35 lb ft).

  3. Lower the vehicle.
scientia non olet · About LEMON Manuals