LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 44 (Hydraulic Brake System) >> Repair Instructions >> Brake Pedal Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply a light coating of silicone lubricant to the brake pedal pivot spacer.
    2. Fig 1: View Of Brake Pedal Pivot Bushing & Spacer
    GM1994001Courtesy of GENERAL MOTORS CORP.
  2. Install the brake pedal pivot bushings (1) and spacer (2).
    3. Fig 2: View Of Brake Pedal Assembly
    GM1994000Courtesy of GENERAL MOTORS CORP.
  3. Install the brake pedal (1).
    4. NOTE: Refer to Fastener Notice .
    Fig 3: View Of Brake Pedal Assembly, Bolt & Nut
    GM1993999Courtesy of GENERAL MOTORS CORP.
  4. Install the brake pedal bolt (1) and nut (2).

    Tighten:  Tighten the bolt and nut to 40 N.m (30 lb ft).

    5. Fig 4: View Of Brake Pedal Pushrod Nut
    GM1993998Courtesy of GENERAL MOTORS CORP.
  5. Connect the brake pedal pushrod (1) to the brake pedal.
    6. Fig 5: Identifying Brake Pedal Pushrod Bushing
    GM1993997Courtesy of GENERAL MOTORS CORP.
  6. Install the brake pedal pushrod bushing (1).
    7. Fig 6: Identifying Brake Pedal Pushrod Nut
    GM1993996Courtesy of GENERAL MOTORS CORP.
  7. Install the brake pedal pushrod nut (1).

    Tighten:  Tighten the nut to 13 N.m (115 lb in).

  8. Install the wiring harness to the bracket clips.
  9. Install the brake pedal position sensor. Refer to Brake Pedal Position Sensor Replacement .
  10. Insert the top of the BCM up into the mounting bracket, then engage the bottom of the BCM into the mounting bracket slot.
  11. Install the left instrument panel insulator. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
scientia non olet · About LEMON Manuals