LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Wiring Systems And Power Management - Introduction) >> Repair Instructions >> Ignition Lock Cylinder Solenoid Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Theft Deterrent Lock, Black Connector & Screw
    GM626493Courtesy of GENERAL MOTORS CORP.
  1. Snap the ignition lock cylinder solenoid (1) onto the ignition lock cylinder case assembly.
  2. Install the tapping screw (3) into the mounting hole of the ignition lock cylinder solenoid (1) and the ignition switch assembly.
  3. Install the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement .
  4. Install the black connector into the ignition lock cylinder solenoid (2).
    5. Fig 2: View Of Lower Trim Cover
    GM1702768Courtesy of GENERAL MOTORS CORP.
  5. Install the lower trim cover onto the steering column.
  6. Snap the lower trim cover to the upper trim cover.
    7. CAUTION: Refer to SIR Inflator Module Coil Caution .
  7. Install the steering wheel onto the steering column. Refer to Steering Wheel Replacement .
  8. Install the steering column into the vehicle. Refer to Steering Column Replacement .
  9. Install the tilt lever. Refer to Tilt Lever Replacement
  10. Enable the SIR system. Refer to SIR Disabling and Enabling .
scientia non olet · About LEMON Manuals