LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Wiring Systems And Power Management - Introduction) >> Repair Instructions >> Ignition Lock Cylinder Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of Ignition Cylinder Lock, Ignition Lock Cylinder Case Assembly and Upper Steering Column
    GM375309Courtesy of GENERAL MOTORS CORP.
  1. Install the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
  2. Install the ignition lock cylinder by performing the following procedure:
    1. Align the positioning locking tab slot on the ignition lock cylinder case to the positioning tab on the ignition lock cylinder.
    2. Push the lock cylinder in until the tab locks in the ignition lock cylinder case.
  3. Enable the SIR system. Refer to SIR Disabling and Enabling .
  4. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (L26) or Battery Negative Cable Disconnection and Connection (LY7) or Battery Negative Cable Disconnection and Connection (LS4) .
  5. Perform the Passlock Learn procedure. Refer to Immobilizer System Component Programming (Canada) or Immobilizer System Component Programming (North America except Canada) .
scientia non olet · About LEMON Manuals