LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Automatic Transaxle - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Vehicle Speed Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the right front tire and wheel. Refer to Tire and Wheel Removal and Installation .
    3. Fig 1: View Of Vehicle Speed Sensor (VSS) Electrical Connector
    GM161100Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the vehicle speed sensor (VSS) electrical connector.
    4. Fig 2: Identifying Vehicle Speed Sensor (VSS)
    GM10516Courtesy of GENERAL MOTORS CORP.
  4. Remove the VSS bolt (9).
  5. Remove the VSS (10) from the extension case.
    6. Fig 3: View Of VSS & O-Ring
    GM10711Courtesy of GENERAL MOTORS CORP.
  6. Remove the O-ring (11) from the VSS (10).
scientia non olet · About LEMON Manuals