LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Automatic Transaxle - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Transmission Mount Replacement - Left Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Transaxle Mount
    GM462438Courtesy of GENERAL MOTORS CORP.
  1. Position the transaxle mount to the frame.
    2. NOTE: Refer to FASTENER NOTICE .
  2. Install the transaxle mount lower nuts to the frame.

    Tighten:  Tighten the transaxle mount lower nuts to 63 N.m (46 lb ft).

  3. Lower the transaxle so the transaxle mount studs install into the transaxle bracket.
    4. Fig 2: View Of Transmission/Transaxle Mount
    GM630964Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE .
  4. Install the transaxle mount upper nuts to the transaxle mount.

    Tighten:  Tighten the transaxle mount upper nuts to 47 N.m (35 lb ft).

  5. Remove the transmission jack from the transaxle.
  6. Install left inner splash shield.
  7. Install the left wheel and tire assembly.
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals