LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Automatic Transaxle - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Transmission Control Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the console trim plate. Refer to Front Floor Console Replacement .
  2. Remove the console wiring harness.
    3. Fig 1: Removing/Installing Console Shift Control Wiring Harness
    GM161196Courtesy of GENERAL MOTORS CORP.
  3. Remove the console shift control wiring harness.
  4. Remove the automatic transaxle range selector cable. Refer to Range Selector Lever Cable Replacement .
  5. Disconnect the lightbulb and the retainer from the shiftier.
    6. Fig 2: View Of Console Shift Control Assembly
    GM161200Courtesy of GENERAL MOTORS CORP.
  6. Remove the console shift control retaining nuts.
  7. Remove the console shift control assembly from the vehicle.
scientia non olet · About LEMON Manuals