Installation Procedure
WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
- Install the TCC PWM solenoid (334).
- Install the TCC PWM solenoid retaining clip (314F).
- Connect the TCC PWM solenoid electrical connector.
- Install the oil pump (200) to the valve body (300).
- Install the oil pump body and cover bolts (230, 230).
Tighten:
- Tighten the nine bolts (231) to 12 N.m (106 lb in).
- Tighten the two bolts (230) to 16 N.m (12 lb ft).
- Reposition and connect the electrical connectors to the following:
- Automatic transaxle fluid pressure manual valve position switch assembly (395)
- 2-3 Shift solenoid valve assembly (315B)
- If equipped internal mode switch
- Install the case side cover. Refer to Control Valve Body Cover Replacement .
- Reset the TAP values. Refer to Transmission Adaptive Functions .
NOTE:
Refer to Fastener Notice
.
IMPORTANT:
It is recommended that transmission adaptive pressure (TAP) information be reset. Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, The ECM, PCM or TCM will need to relearn TAP values. Transmission performance may be affected as new TAP values are learned.