LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Automatic Transaxle - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Oil Pump Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Wiring Harness & Electrical Connectors
    GM48209Courtesy of GENERAL MOTORS CORP.
  1. Remove the case side cover. Refer to Control Valve Body Cover Replacement .
  2. Use a flat-bladed tool to disconnect the electrical connectors from the solenoid valves (315A, 315B, 322, 334 and 440), the TFP manual valve position switch (395) and the temperature sensor (391).
    3. Fig 2: Identifying Oil Pump Bolt Lengths & Positions
    GM164795Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do NOT remove the bolt (205) that holds the oil pump together.
  3. Remove the oil pump bolts (206, 207).
    4. Fig 3: Oil Pump & Valve Body View
    GM48212Courtesy of GENERAL MOTORS CORP.
  4. Remove the oil pump (200) from the valve body (300).
scientia non olet · About LEMON Manuals