LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Automatic Transaxle - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Oil Pan Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Transaxle Oil Pan & Gasket
    GM164804Courtesy of GENERAL MOTORS CORP.
  1. Install the oil pan gasket (25).
  2. Install the oil pan (24).
    3. NOTE: Refer to Fastener Notice .
  3. Install the oil pan bolts (23).

    Tighten:  Tighten the bolts to 14 N.m (10 lb ft).

  4. Lower the vehicle.
    5. NOTE: Refer to TRANSMISSION OVERFILL NOTICE .
  5. Fill the transaxle. Refer to Fluid Capacity Specifications .
  6. Place the gear selector in the PARK position.
  7. Start the engine.
  8. Run the engine at a slow idle. Do NOT race the engine.
  9. Adjust the fluid level.
  10. Inspect for leaks.
scientia non olet · About LEMON Manuals