LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Automatic Transaxle - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Front Wheel Drive Shaft Oil Seal Replacement - Right Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate the seal lip with transaxle fluid.
  2. Install J 37292-B  in the seal (4). See Special Tools .
    3. Fig 1: Identifying Right Front Oil Seal
    GM190628Courtesy of GENERAL MOTORS CORP.
  3. Use J 29130  to install the new seal (4). See Special Tools .
  4. Remove the J 37292-B  . See Special Tools .
    5. IMPORTANT: Carefully guide the axle shaft past the lip seal. Do NOT allow the shaft splines to contact any portion of the seal lip surface.
  5. Install the drive axle to the transaxle. Refer to Wheel Drive Shaft Replacement .
  6. Install the right lower ball joint to the right steering knuckle. Refer to Steering Knuckle Replacement .
  7. Install the right tie rod end to the right steering knuckle. Refer to Steering Knuckle Replacement .
  8. Install the right stabilizer shaft link to the right steering knuckle. Refer to Stabilizer Shaft Link Replacement .
  9. Install the right front tire and wheel. Refer to Tire and Wheel Removal and Installation .
  10. Lower the vehicle.
    11. NOTE: Refer to Transmission Overfill Notice .
  11. Check and fill the transaxle fluid as necessary.
  12. Inspect for fluid leaks.
scientia non olet · About LEMON Manuals