LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Automatic Transaxle - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Front Wheel Drive Shaft Oil Seal Replacement - Left Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Front Wheel Drive Shaft Oil Seal - Left
    GM164799Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the left front tire and wheel. Refer to Tire and Wheel Removal and Installation .
  3. Remove the left stabilizer shaft link from the left lower control arm. Refer to Stabilizer Shaft Link Replacement .
  4. Remove the left tie rod end from the left steering knuckle. Refer to Steering Knuckle Replacement .
  5. Remove the left lower ball joint from the left steering knuckle. Refer to Steering Knuckle Replacement .
  6. Remove the left drive axle from the transaxle. Refer to Wheel Drive Shaft Replacement .
  7. Secure the left drive axle to the left steering knuckle and the strut.
  8. Use a flat bladed screwdriver or a suitable tool to remove the oil seal (409) from the transaxle side case (401).
scientia non olet · About LEMON Manuals