LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Automatic Transaxle - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Front Wheel Drive Shaft Oil Seal Replacement - Left Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate the seal lip with transaxle fluid.
    2. IMPORTANT: Carefully guide the axle shaft past the lip seal. Do NOT allow the shaft splines to contact any portion of the seal lip surface.
  2. Install J 37292-B  in the seal (409). See Special Tools .
    3. Fig 1: Identifying Left Oil Seal
    GM190634Courtesy of GENERAL MOTORS CORP.
  3. Use J 34115  to install the new seal. See Special Tools .
  4. Remove the J 37292-B  . See Special Tools .
  5. Install the drive axle to the transaxle. Refer to Wheel Drive Shaft Replacement .
  6. Install the left lower ball joint to the left steering knuckle. Refer to Steering Knuckle Replacement .
  7. Install the left tie rod end to the left steering knuckle. Refer to Steering Knuckle Replacement .
  8. Install the left stabilizer shaft link to the left lower control arm. Refer to Stabilizer Shaft Link Replacement .
  9. Install the left front tire and wheel. Refer to Tire and Wheel Removal and Installation .
  10. Lower the vehicle.
    11. NOTE: Refer to TRANSMISSION OVERFILL NOTICE .
  11. Adjust the fluid level.
  12. Inspect for proper completion of the repairs.
  13. Inspect for proper fluid level.
  14. Inspect for fluid leaks.
scientia non olet · About LEMON Manuals