LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Automatic Transaxle - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Case Extension Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Case Extension Assembly & Bolts
    GM10517Courtesy of GENERAL MOTORS CORP.
  1. Install the O-ring (8) to the case extension housing (6).
  2. Install the case extension housing (6) with the axle seal and the O-ring (8).
    3. NOTE: Refer to FASTENER NOTICE .
  3. Install the case extension housing bolts (5).

    Tighten:  Tighten the bolts to 36 N.m (27 lb ft).

  4. Install the vehicle speed sensor. Refer to Vehicle Speed Sensor Replacement .
  5. Install the transaxle brace. Refer to Transmission Brace Replacement .
  6. Install the right drive axle to the transaxle. Refer to Wheel Drive Shaft Replacement .
  7. Lower the vehicle.
  8. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (L26) or Battery Negative Cable Disconnection and Connection (LY7) or Battery Negative Cable Disconnection and Connection (LS4) .
    9. NOTE: Refer to TRANSMISSION OVERFILL NOTICE .
  9. Check and fill the transaxle as necessary.
  10. Inspect for fluid leaks.
scientia non olet · About LEMON Manuals