LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Automatic Transaxle - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> 2-3 Shift Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the case side cover. Refer to Control Valve Body Cover Replacement .
  2. Disconnect the 2-3 shift solenoid electrical connector.
  3. Remove the 2-3 shift solenoid retaining clip (314C).
    4. Fig 1: View Of 2-3 Shift Solenoid & O-Ring
    GM49385Courtesy of GENERAL MOTORS CORP.
  4. Remove the 2-3 shift solenoid (315B) and the O-ring (316).
scientia non olet · About LEMON Manuals