LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Automatic Transaxle - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Torque Converter Fluid Seal Removal >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Cross Sectional View Of J 41103 Components
    GM1239231Courtesy of GENERAL MOTORS CORP.
  1. Insert the three J 41103-1  puller legs under the Torque Converter Seal (525). See Special Tools .
  2. Insert the J 41103-3  support body over the drive sprocket support (522). See Special Tools .
  3. Insert the J 41103-2  puller bridge over the J 41103-3  support body. See Special Tools . Connect the J 41103-1  puller legs into the slots on the J 41103-2  bridge. See Special Tools .
    4. IMPORTANT: The puller legs will damage the torque converter seal (525). Discard the torque converter seal (525) after removal.
  4. Tighten the forcing screw on the J 41103-2  puller bridge until the J 41103-1  puller legs remove the torque converter seal (525). See Special Tools .
scientia non olet · About LEMON Manuals