LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Automatic Transaxle - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Thermo Element Adjustment >> Adjustment Procedure

Adjustment Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Thermo Element, Plate & Plate Pins
    GM13015Courtesy of GENERAL MOTORS CORP.
  1. Remove the thermo element plate pins (120).
  2. Remove the thermo element (121) and the thermo element plate (122).
    3. Fig 2: Setting Height Of Thermo Element Plate Pins
    GM13016Courtesy of GENERAL MOTORS CORP.
  3. Use J 34094-A  in order to set the height of the thermo element plate center pin (123). See Special Tools .
  4. Install the thermo element plate (122).
  5. Use J 34094-A  in order to set the height of the thermo element plate pin (120) that is farthest from the accumulators. See Special Tools .
  6. Use J 34094-A  in order to set the height of the second thermo element plate pin (120). See Special Tools .
    7. Fig 3: View Of Thermo Element, Plate & Plate Pins
    GM13015Courtesy of GENERAL MOTORS CORP.
  7. Carefully install the thermo element (121) between the two thermo element plate pins (120).
  8. The V in the thermo element (121) must contact the thermo element plate (123).
scientia non olet · About LEMON Manuals