LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Automatic Transaxle - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Second, Input, Third and Sprag Clutches Assemble >> Assembly Procedure

Assembly Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Thrust Bearing Assembly & Selective Thrust Washer
    GM10683Courtesy of GENERAL MOTORS CORP.
  1. Install the selective thrust washer (630) and the thrust bearing assembly (629) onto the input clutch housing assembly (632).
    2. Fig 2: View Of Second Clutch Housing Assembly & Second Clutch Hub
    GM49257Courtesy of GENERAL MOTORS CORP.
  2. Use a small screwdriver in order to align the second clutch teeth so that they slide onto the second clutch hub of the input clutch housing assembly (632).
  3. Install the second clutch housing assembly (617) onto the second clutch hub of the input clutch housing assembly (632).
    4. Fig 3: View Of J 33381-A
    GM10544Courtesy of GENERAL MOTORS CORP.
  4. Adjust the collar on J 33381-A  to 4T65-E CLUTCH & DRUM. See Special Tools . Make sure that the threaded rod is fully loosened.
    5. Fig 4: Identifying J 33381-A & Input Clutch Housing Assembly
    GM48267Courtesy of GENERAL MOTORS CORP.
  5. Install J 33381-A  into the input clutch housing assembly (632). See Special Tools .
  6. Tighten the threaded rod of J 33381-A  until the rod is finger tight. See Special Tools .
  7. Use J 33381-A  in order to lift the input and second clutch housing assembly (617, 632). See Special Tools . The sprag clutch assemblies will also be attached.
    8. IMPORTANT: After you have installed the input and second clutch housing assembly, confirm that the top of the second clutch housing (617) is approximately 1/2 inch above the top of the reverse band assembly.
  8. Install the input and second clutch housing assembly (617, 632) into the case. Be sure that the assembly is down all the way.
scientia non olet · About LEMON Manuals