LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Automatic Transaxle - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Reverse Servo Removal

Reverse Servo Removal

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Reverse Servo Cover Snap Ring
    GM48166Courtesy of GENERAL MOTORS CORP.
  1. Use a long screwdriver in order to depress the reverse band servo cover (40) by prying against the transmission holding fixture.
  2. Use a small screwdriver in order to pry out the retaining ring (39) from the reverse band servo cover.
    3. Fig 2: Identifying Reverse Servo Assembly Components
    GM48173Courtesy of GENERAL MOTORS CORP.
  3. Remove the long screwdriver. The servo assembly will push the servo cover (40) up.
  4. Remove the servo cover (40) and the servo cover O-ring seal (41).
  5. Remove the reverse band servo assembly (42-48).
  6. Remove the reverse band servo piston spring (49).
scientia non olet · About LEMON Manuals