LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Automatic Transaxle - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Input Clutch Housing Fluid Seal Ring Assemble >> Assembly Procedure

Assembly Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying J 34741-1 & Input Clutch Housing
    GM10655Courtesy of GENERAL MOTORS CORP.
  1. Install J 34741-1  into the input clutch housing (632). See Special Tools . Adjust J 34741-1  so that the bottom of the seal installer aligns with the lowest seal ring groove. See Special Tools .
  2. Use transmission fluid in order to lubricate the oil seal ring for the input clutch housing. Position the ring on the J 34741-1  . See Special Tools .
    3. Fig 2: Using J 34741-2 & J 34741-1 To Install Seal Rings
    GM10657Courtesy of GENERAL MOTORS CORP.
  3. Position J 34741-2  onto the J 34741-1  . See Special Tools . Push the seal (628) into the seal ring groove.
    4. Fig 3: Locating Second & Third Seal Rings
    GM10656Courtesy of GENERAL MOTORS CORP.
  4. Repeat this procedure for the second and the third seal rings (628).
    5. Fig 4: Identifying J 34741-3 & Input Clutch Housing Assembly
    GM10658Courtesy of GENERAL MOTORS CORP.
  5. Remove the input seal installer.
  6. Use a twisting motion in order to assemble J 34741-3  over the seals. See Special Tools .
  7. Leave J 34741-3  in place until the input clutch housing assembly (632) is assembled into the transmission. See Special Tools .
scientia non olet · About LEMON Manuals