LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Automatic Transaxle - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Forward Servo Removal

Forward Servo Removal

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Compressing Forward Band Servo Assembly
    GM48177Courtesy of GENERAL MOTORS CORP.
  1. Position the transmission so that the oil pan is facing up.
  2. Use a long screwdriver in order to compress the forward band servo assembly cover (13) by prying against the work bench.
  3. Hold the servo assembly compressed.
    4. Fig 2: View Of Servo Assembly
    GM48181Courtesy of GENERAL MOTORS CORP.
  4. Remove the three forward band servo cover bolts (12).
  5. Remove the long screwdriver. The servo assembly will push the servo cover out. If the servo cover does not push out, tap it with a rubber mallet.
  6. Remove the servo cover (13) and remove the cover seal (14).
  7. Remove the servo assembly (15-21).
  8. Remove the piston spring (22) from the forward band servo.
scientia non olet · About LEMON Manuals