LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Automatic Transaxle - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Forward Band Assemble

Forward Band Assemble

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Forward Band Assembly Inspection Areas
    GM10610Courtesy of GENERAL MOTORS CORP.
  1. Inspect the forward band assembly (688) for the following conditions:
    • Damaged or severely worn friction material
    • Damaged apply or anchor pin features
  2. Inspect the bearing (691) from the differential carrier internal gear for damage.
    3. Fig 2: Identifying Forward Band Assembly & Bearing
    GM893330Courtesy of GENERAL MOTORS CORP.
  3. Position the transmission case so that the flange for the case cover is facing up.
  4. Install the bearing (691) for the differential carrier internal gear into the case. Position as indicated.
  5. Install the forward band assembly (688) into the case.
    • Locate the band assembly onto the forward band anchor pin
    • Position the band apply pin feature in the opening of the case
scientia non olet · About LEMON Manuals