Driven Sprocket Support Bearing Assemble

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required

J 34126 Sprocket/Remover Bearing Remover
J 8092 Driver Handle

Fig 1: Using J 34126 & J 8092 To Install Driven Sprocket Support Bearing Assembly

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Position the driven sprocket support bearing assembly so that markings on the edge are facing up.

Use J 34126 (2), J 8092 (1) and a hammer in order to seat the driven sprocket support bearing assembly flush with or below the driven sprocket support assembly (609) hub.