LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Automatic Transaxle - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Driven Sprocket Support Assembly Removal

Driven Sprocket Support Assembly Removal

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Driven Sprocket Support Assembly
    GM870974Courtesy of GENERAL MOTORS CORP.
  1. With your fingers, insert two 13 mm channel plate bolts (434) into the driven sprocket support assembly (609).
  2. Grasp the bolts and lift the support assembly from the case.
  3. Remove the thrust washer (611) from the second clutch housing. The washer may be stuck to the support assembly.
scientia non olet · About LEMON Manuals