LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Automatic Transaxle - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Driven Sprocket Support Assemble >> Assembly Procedure

Assembly Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Second Clutch Housing Thrust Washer
    GM10685Courtesy of GENERAL MOTORS CORP.
  1. Use J 36850  or equivalent in order to secure the second clutch housing thrust washer (611) to the driven sprocket support assembly (609).
    2. Fig 2: View Of Case Cover Bolts & Driven Sprocket Support Assembly
    GM893332Courtesy of GENERAL MOTORS CORP.
  2. Finger start two 13 mm case cover bolts (434) into the driven sprocket support assembly (609).
    3. IMPORTANT: If the driven sprocket support assembly (609) is not flush with or slightly below the case, then one of the clutches is not fully seated.
  3. Using the bolts (434), lift the driven sprocket support assembly (609) into the case and align as shown. The top of the driven sprocket support assembly (609) should be flush with the case.
scientia non olet · About LEMON Manuals