LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Automatic Transaxle - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Drive Sprocket and Turbine Shaft Disassemble

Drive Sprocket and Turbine Shaft Disassemble

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Seal Rings & Turbine Shaft
    GM49261Courtesy of GENERAL MOTORS CORP.
    NOTE: Do not damage the grooves on the shaft, when removing the oil seal rings.
  1. Cut the oil seal rings (513, 519) from the turbine shaft (518).
  2. Remove the oil seal rings (513, 519).
    3. Fig 2: View Of Turbine Drive Sprocket & Retaining Ring
    GM49262Courtesy of GENERAL MOTORS CORP.
  3. Remove the drive sprocket retaining ring (515).
  4. Remove the drive sprocket (516) from the turbine shaft (518).
scientia non olet · About LEMON Manuals