Drive Sprocket Support Assemble

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required

J 8092 Driver Handle
J 28677 Drive Sprocket Support Bearing Installer. See Special Tools .
J 36850 Transmission Assembly Lubricant

Fig 1: Pressing In Drive Sprocket Support Bearing With J 8092 & J 28677

Courtesy of GENERAL MOTORS CORP.

Assemble J 28677 and J 8092 . See Special Tools .
Lubricate drive sprocket support bearing (521) with J 36850 .

IMPORTANT: When installing the new bearing the part number should be visible (facing upward).

Using the assembled tool, press in the drive sprocket support bearing (521).

Fig 2: Locating Drive Sprocket Support Assembly

Courtesy of GENERAL MOTORS CORP.

Install the drive sprocket support assembly (522).

NOTE: Refer to FASTENER NOTICE .

Install the four drive sprocket support bolts (524).
Tighten: Tighten the bolts to 25 N.m (18 lb ft).