Drive Shaft Oil Seal Assemble - Right Side (FWD Only)

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required

J 29130 Axle Seal Installer. See Special Tools .
J 8092 Driver Handle

Fig 1: Identifying Axle Oil Seal With J 29130 & J 8092

Courtesy of GENERAL MOTORS CORP.

NOTE: Install the seal onto the tool before installing into the case to prevent damage to the seal.

IMPORTANT: Inspect the axle oil seal assembly (4). Be sure that the seal was not damaged during assembly. Check that the garter spring was not dislodged.

Use J 29130 and J 8092 in order to install the axle oil seal assembly (4) on the case extension assembly.