LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Automatic Transaxle - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Drive Shaft Oil Seal Assemble - Left Side >> Assembly Procedure

Assembly Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Left Side Axle Oil Seal Assembly
GM49309Courtesy of GENERAL MOTORS CORP.
NOTE: Install the seal onto the tool before installing into the case to prevent damage to the seal.
IMPORTANT: When you remove a drive axle from the transmission for any reason, inspect the axle sealing surface (tripot shank) for corrosion. If corrosion is evident, clean the surface with a 320 grit cloth or equivalent. Clean off any remaining debris with automatic transmission fluid. Wipe the surface dry and reinstall the drive axle free of any build up.

Use J 34115  in order to install the left side axle oil seal assembly (409). See Special Tools .

scientia non olet · About LEMON Manuals