Drive Link Stretch Check
WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
- Make sure that the driven sprocket support (609) and both sprockets (506, 516) are fully seated.
- Pull the drive link assembly (507) toward the case at the indicated location.
- Measure the distance between the case and the drive link assembly (507):
- If the measurement is 3.2 mm (1/8 in) or greater, reuse the drive link assembly (507).
- If the measurement is less than 3.2 mm (1/8 in), replace the drive link assembly (507).