LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Automatic Transaxle - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Differential Carrier Components Assemble (FWD Only) >> Assembly Procedure

Assembly Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Differential Carrier
    GM214412Courtesy of GENERAL MOTORS CORP.
  1. Assemble the final drive sun gear (697) with the chamfered side toward the parking gear (696) into the differential/final drive carrier assembly (700).
  2. Assemble the parking gear (696) onto the final drive sun gear shaft (689)
  3. Assemble the final drive sun gear shaft/parking gear assembly (689/696) into the final drive sun gear (697).
    4. IMPORTANT: Apply J 36850  or equivalent to the parking gear side of the bearing (695).
  4. Assemble the internal gear/parking gear thrust bearing (695) to the parking gear (696).
    5. Fig 2: Identifying Differential Carrier
    GM214413Courtesy of GENERAL MOTORS CORP.
  5. Install the differential/final drive carrier assembly into the case.
scientia non olet · About LEMON Manuals