LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Automatic Transaxle - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Case Extension Assembly Removal

Case Extension Assembly Removal

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Differential/Final Drive Carrier Assembly Thrust Bearing
    GM10554Courtesy of GENERAL MOTORS CORP.
  1. Remove the two case extension bolts (5).
  2. Remove the case extension assembly (6) and remove the seal (8).
  3. Remove the differential carrier thrust washer (715).
  4. Remove the differential carrier thrust bearing (714).
scientia non olet · About LEMON Manuals