LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Automatic Transaxle - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Case Cover Components Assemble (With Touch Activated Power)

Case Cover Components Assemble (With Touch Activated Power)

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating 3-4 Accumulator Piston Components
    GM330198Courtesy of GENERAL MOTORS CORP.
  1. Install a new 3-4 accumulator piston cylinder O-ring seal (422) onto the 3-4 accumulator piston cylinder (421).
  2. Install the 3-4 accumulator piston outer spring (423) and inner spring (424) into the 3-4 accumulator piston cylinder (421).
  3. Install a new 3-4 accumulator piston seal (427) onto the 3-4 accumulator piston (428).
  4. Insert the 3-4 accumulator piston (428) into the 3-4 accumulator piston cylinder (421).
  5. Using a slight twisting motion, insert the 3-4 accumulator piston cylinder (421) into the case cover (401).
  6. Insert the 3-4 accumulator piston pin (426) through the front of the case cover (401) and into the 3-4 accumulator piston (428).
  7. Install the manual valve (404) into the case cover (401).
    8. Fig 2: Expanded View Of Case Cover Components
    GM1174545Courtesy of GENERAL MOTORS CORP.
  8. Install the actuator feed limit valve (414) into the case cover (401).
  9. Install the actuator feed limit valve spring (415) into the case cover (401).
  10. Install the actuator feed limit valve spring retainer (416) into the case cover (401).
  11. Install the low regulator valve spring (442).
  12. Install the low regulator valve (443).
  13. Install the low regulator valve bore plug (444).
scientia non olet · About LEMON Manuals