Case Cover Bearing Disassemble

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required

J 8092 Driver Handle. See Special Tools .
J 41991 Driveshaft Bearing Remover/Installer. See Special Tools .

Fig 1: Identifying Drive Shaft Bearing Assembly

Courtesy of GENERAL MOTORS CORP.

Assemble J 8092 and J 41991 for bearing removal. See Special Tools .
Place the case cover (400) on a clean, flat surface with the spacer plate mating surface up.
Using the assembled tool, press the drive shaft bearing assembly (431) from the case cover (400).