Case Components Assemble

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Oil Pressure Test Hole Plug & Vent Assembly

Courtesy of GENERAL MOTORS CORP.

Use a hammer and a punch in order to install the vent assembly (37), if necessary.
Apply sealant GM P/N 12345382 to the oil pressure test hole plug (38).

NOTE: Refer to FASTENER NOTICE .

Install the oil pressure test hole plug (38).
Tighten: Tighten the oil pressure test hole plug (38) to 12 N.m (106 lb in).