LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Automatic Transaxle - 4T65-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> 2nd Clutch and Input Clutch Removal >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of J 33381-A
    GM10544Courtesy of GENERAL MOTORS CORP.
  1. Adjust the collar on tool J 33381-A  to the 4T65-E CLUTCH & DRUM setting. See Special Tools . Make sure that the threaded rod is fully loosened.
    2. Fig 2: Identifying J 33381-A & Input Clutch Housing Assembly
    GM48267Courtesy of GENERAL MOTORS CORP.
  2. Install J 33381-A  into the second clutch housing assembly (617). See Special Tools .
  3. Tighten the threaded rod of J 33381-A  until the rod is finger tight. See Special Tools .
  4. Lift up J 33381-A  with the second clutch housing (617) and the input clutch housing (632) attached. See Special Tools . The sprag clutch assemblies will also be attached.
  5. Place the complete assembly on the bench.
  6. Loosen the threaded rod of J 33381-A  . See Special Tools .
  7. Remove J 33381-A  from the assembly. See Special Tools .
    8. Fig 3: Identifying Second Clutch Housing & Input Clutch Components
    GM48591Courtesy of GENERAL MOTORS CORP.
  8. Lift the second clutch housing (617) off of the input clutch housing.
  9. Remove the input clutch housing thrust bearing (629) from the input housing.
  10. Remove the selective thrush washer (630) from the input clutch housing (632).
scientia non olet · About LEMON Manuals