LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (Power Steering System) >> Repair Instructions >> Steering Gear Stub Shaft Seal and Bearing Replacement - Off Vehicle >> Disassembly Procedure

Disassembly Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Adjuster Plug Lock Nut & Adjuster Plug
    GM470307Courtesy of GENERAL MOTORS CORP.
  1. Remove the steering gear from the vehicle, refer to Steering Gear Replacement .
  2. Remove the adjuster plug lock nut (5) from the adjuster plug (4).
  3. Remove the adjuster plug (4) from the gear assembly (1).
  4. Remove the adjuster spring (3) and the rack bearing (2).
    5. Fig 2: View Of Rack And Pinion Gear Assembly Components
    GM470308Courtesy of GENERAL MOTORS CORP.
  5. Remove the spool shaft boot (1) from the rack and pinion gear assembly.
  6. Remove the retaining ring (2) from the valve bore of the rack and pinion gear assembly.
  7. Remove the dust cover (4) from the bottom of the rack and pinion gear assembly.
  8. Remove the hex lock nut (3) from the lower end of the pinion and valve assembly while holding the stub shaft with a 14 mm crowfoot wrench.
    9. Fig 3: View Of Stub Shaft Assembly
    GM416151Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: When performing the following procedure, do not remove pinion and valve assembly from the rack and pinion gear assembly (5). Press the pinion and valve assembly only far enough to allow removal of the stub shaft bearing annulus (3) and the stub shaft seal (2).
  9. Using an arbor press (1), press on the threaded end of the pinion until removal of the following items is possible:
    1. The stub shaft (4)
    2. The stub shaft seal (2)
    3. The stub shaft bearing annulus assembly (3)
scientia non olet · About LEMON Manuals