LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (Power Steering System) >> Repair Instructions >> Steering Gear Cylinder Pipe Assembly and Seals Replacement - Off Vehicle (Magnasteer) >> Disassembly Procedure

Disassembly Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of Cylinder Line Fittings & Cylinder Line Assemblies
    GM423433Courtesy of GENERAL MOTORS CORP.
  1. Loosen both cylinder line fittings (1) on the cylinder end of the gear assembly.
  2. Loosen both fittings on the cylinder line assemblies (3) at the valve end of the gear assembly.
    3. Fig 2: View Of Cylinder Line Assemblies & Rack & Pinion Gear Assembly
    GM423434Courtesy of GENERAL MOTORS CORP.
  3. Remove both cylinder line assemblies (1) from the rack and pinion gear assembly (2).
    4. Fig 3: View Of Steering Fittings At Rack
    GM423437Courtesy of GENERAL MOTORS CORP.
  4. Remove the O-ring seals (1) from the valve end of line.
  5. Discard the O-ring seals (1).
scientia non olet · About LEMON Manuals