LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (Power Steering System) >> Repair Instructions >> Rack and Pinion Outer Tie Rod End Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Outer Tie Rod Assembly & Inner Tie Rod Assembly
    GM297355Courtesy of GENERAL MOTORS CORP.
  1. Install the outer tie rod assembly (3) to the inner tie rod assembly (1). Do NOT tighten the jam nut (2).
    2. Fig 2: View Of Outer Tie Rod & Steering Knuckle
    GM297628Courtesy of GENERAL MOTORS CORP.
  2. Install the outer tie rod assembly (2) to the steering knuckle (1).
    3. Fig 3: Identifying Outer Tie Rod & Retaining Nut
    GM575833Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. Install the prevailing torque nut (2) to the outer tie rod assembly (1).

    Tighten:  Tighten the nut to 30 N.m plus 120 degrees (22 lb ft plus 120 degrees). Inspect to ensure that 21/2-41/2 threads are visible above the nylon washer.

  4. Install tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  5. Lower the vehicle.
  6. Perform a front end alignment. Refer to Wheel Alignment Measurement .
scientia non olet · About LEMON Manuals