LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (Power Steering System) >> Repair Instructions >> Power Steering Cooler Pipe/Hose Replacement (L26) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the power steering cooler hose to the vehicle.
  2. Clip the power steering cooler hose to any front frame retainers as needed.
    3. Fig 1: View Of Cooler Pipe/Hose
    GM284303Courtesy of GENERAL MOTORS CORP.
  3. Install the power steering cooler hose to the power steering pump.
    4. Fig 2: View Of Power Steering Hoses
    GM294335Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  4. Install the power steering cooler hose to the steering gear.

    Tighten:  Tighten the fitting to 27 N.m (20 lb ft).

  5. Clean any excess fluid from the vehicle and remove the drain pans.
  6. Install the right front tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  7. Install the drive belt. Refer to Drive Belt Replacement (L26) .
  8. Fill and bleed the power steering system. Refer to Power Steering System Bleeding .
scientia non olet · About LEMON Manuals