LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (Power Steering System) >> Diagnostic Information and Procedures >> DTC C0450 >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the VES actuator harness connector.
  2. Measure for 1.6-3.1 ohms between the VES actuator terminals A and B.
    • If not within the specified range, replace the VES actuator.
  3. Measure for infinite ohms of resistance between each VES actuator terminal and the VES actuator housing.
    • If less than the specified range, replace the VES actuator.
scientia non olet · About LEMON Manuals