LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Front Suspension System) >> Repair Instructions >> Front Wheel Bearing and Hub Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
    3. Fig 1: View Of Wheel Speed Sensor, Connector And Harness
    GM188809Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the wheel speed sensor electrical connector (2), if equipped.
    4. Fig 2: View Of Wheel Speed Sensor Electrical Connector & Bracket
    GM477813Courtesy of GENERAL MOTORS CORP.
  4. Remove the wheel speed sensor electrical connector from the bracket, if equipped.
    5. Fig 3: Preventing Rotor Turning Using Drift Or Punch
    GM141983Courtesy of GENERAL MOTORS CORP.
  5. Remove the front wheel drive shaft nut (2). Insert a drift or flat-bladed tool (1) into the caliper and rotor to prevent from turning.
  6. Remove the brake rotor. Refer to Front Brake Rotor Replacement .
    7. Fig 4: View Of Front Hub Spindle Remover
    GM40253Courtesy of GENERAL MOTORS CORP.
  7. Use 3 wheel nuts in order to attach the J 42129  to the wheel bearing/hub.
  8. Use the J 42129  in order to push the wheel drive shaft out of the wheel bearing/hub.
    9. Fig 5: View Of Wheel Bearing/Hub & Splash Shield
    GM357695Courtesy of GENERAL MOTORS CORP.
  9. Remove and DISCARD the wheel bearing/hub bolts. Remove the J 42129  from the hub.
    10. IMPORTANT: Ensure that the wheel drive shaft outer seal/boot is not damaged.
  10. Remove the wheel bearing/hub and splash shield-noting the position of the shield for re-installation.
scientia non olet · About LEMON Manuals