LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Engine Mechanical - 5.3L) >> Repair Instructions - On Vehicle >> Oil Level Indicator and Tube Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Level Indicator & Tube
    GM1411879Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the O-ring seal with clean engine oil.
  2. Install the O-ring seal onto the oil level indicator tube, if necessary.
  3. Install the oil level indicator tube (420) to the engine block. The tube must be installed with the collar flush to the block.
    4. NOTE: Refer to Fastener Notice .
  4. Install the oil level indicator tube bolt (419)

    Tighten:  Tighten the bolt to 25 N.m (18 lb ft).

  5. Install the oil level indicator (418) to the tube.
scientia non olet · About LEMON Manuals