LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Engine Mechanical - 5.3L) >> Repair Instructions - On Vehicle >> Engine Oil Level Sensor and/or Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Pan, Drain Plug & O-Ring, Oil Level Sensor, Bolt & O-Ring
    GM1411954Courtesy of GENERAL MOTORS CORP.
  1. Install the oil level sensor (727) and O-ring (728) to the oil pan.
    2. NOTE: Refer to Fastener Notice .
  2. Install the oil level sensor bolt (751).

    Tighten:  Tighten the bolt to 20 N.m (15 lb ft).

    3. Fig 2: View Of Oil Level Sensor Electrical Connector
    GM1551872Courtesy of GENERAL MOTORS CORP.
  3. Connect the oil level sensor electrical connector.
  4. Lower the vehicle.
  5. Refill the engine oil to the proper level.
scientia non olet · About LEMON Manuals