LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Engine Mechanical - 5.3L) >> Repair Instructions - On Vehicle >> Engine Mount Replacement - Left Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Lower Engine Mount
    GM1551858Courtesy of GENERAL MOTORS CORP.
  1. Install the engine mount heat shield, if necessary.
  2. Install the engine mount to the engine.
    3. NOTE: Refer to Fastener Notice .
  3. Install the lower engine mount nuts.

    Tighten:  Tighten the nuts to 50 N.m (37 lb ft).

  4. Lower the vehicle.
    5. Fig 2: View Of Lower Engine Mount & Bolts
    GM1551854Courtesy of GENERAL MOTORS CORP.
  5. Install the engine mount bracket.
  6. Install the engine mount bracket bolts.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

    7. Fig 3: View Of Lower Engine Mount
    GM1551856Courtesy of GENERAL MOTORS CORP.
  7. Using the engine support fixture, lower the engine.
  8. Remove the engine support fixture.
  9. Install the upper engine mount nuts.

    Tighten:  Tighten the nuts to 50 N.m (37 lb ft).

  10. Install the left exhaust manifold. Refer to Exhaust Manifold Installation - Left Side .
  11. Install the engine mount strut. Refer to Engine Mount Strut Replacement .
scientia non olet · About LEMON Manuals