LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Engine Mechanical - 3.6L (2 Of 5)) >> On-Vehicle Repair Information (1 Of 2) >> Engine Mount Replacement - Right Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground (negative) cable. Refer to Battery Negative Cable Disconnection and Connection (LY7) .
  2. Remove the throttle body air inlet duct. Refer to Air Cleaner Inlet Duct Replacement .
  3. Remove the engine mount struts. Refer to Engine Mount Strut Replacement - Left Side  or Engine Mount Strut Replacement - Right Side .
  4. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  5. Remove the three-way catalytic converter pipe from the engine right side exhaust manifold. Refer to Catalytic Converter Replacement .
  6. Remove the right front wheel and tire. Refer to Tire and Wheel Removal and Installation .
  7. Remove the right engine splash shield. Refer to Engine Splash Shield Replacement .
    8. Fig 1: Identifying Engine Mount Lower Nuts
    GM96002Courtesy of GENERAL MOTORS CORP.
  8. Remove the engine mount lower nuts.
    9. Fig 2: Locating Engine Mount Bracket-To-Oil Pan Bolts
    GM1386747Courtesy of GENERAL MOTORS CORP.
    NOTE: In order to avoid oil pan damage and possible engine failure, insert a block of wood that spans the width of the oil pan bottom between the oil pan and the jack support.
  9. Use a utility stand and a block of wood in order to raise the engine.
  10. Remove the engine mount bracket-to-oil pan bolts (2).
  11. Remove the engine mount bracket-to-engine bolts (1).
  12. Remove the engine mount and the engine mount bracket.
    13. Fig 3: Identifying Engine Mount Upper Nuts
    GM96010Courtesy of GENERAL MOTORS CORP.
  13. Remove the engine mount upper nuts.
  14. Remove the engine mount from the engine mount bracket.
scientia non olet · About LEMON Manuals