LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Engine Mechanical - 3.6L (2 Of 5)) >> On-Vehicle Repair Information (1 Of 2) >> Engine Front Cover Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (LY7) .
    2. Fig 1: View Of ECM Bolts
    GM1394049Courtesy of GENERAL MOTORS CORP.
  2. Remove the engine control module (ECM) module. Refer to Engine Control Module Replacement .
    3. Fig 2: View Of Generator Bolts
    GM1394079Courtesy of GENERAL MOTORS CORP.
  3. Remove the generator assembly. Refer to Generator Replacement (LY7) .
  4. Remove the coolant overflow reservoir. Refer to Coolant Recovery Reservoir Replacement (L27, LY7) .
  5. Remove the power steering reservoir. Refer to Remote Power Steering Fluid Reservoir Replacement (LY7) .
  6. Remove the camshaft covers.
  7. Remove the radiator inlet hose. Refer to Radiator Inlet Hose Replacement (LY7) .
  8. Remove the coolant outlet. Refer to Water Outlet Removal .
    9. Fig 3: View Of Water Pump
    GM946142Courtesy of GENERAL MOTORS CORP.
  9. Remove the water pump. Refer to Water Pump Replacement (LY7) .
  10. Remove the engine splash shield. Refer to Engine Splash Shield Replacement .
    11. Fig 4: View Of Crankshaft Balancer
    GM1394039Courtesy of GENERAL MOTORS CORP.
  11. Remove the crankshaft balancer. Refer to Crankshaft Balancer Removal .
  12. Remove the drive belt tensioner. Refer to Drive Belt Tensioner Replacement .
    13. Fig 5: View Of Engine Front Cover
    GM1412167Courtesy of GENERAL MOTORS CORP.
  13. Remove the engine front cover from the engine block. Refer to Engine Front Cover Removal .
scientia non olet · About LEMON Manuals