LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Engine Mechanical - 3.6L (2 Of 5)) >> On-Vehicle Repair Information (1 Of 2) >> Camshaft Position Actuator Replacement - Bank 2 (Left Side) Intake >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Camshaft Position Actuator Bolt
    GM1852296Courtesy of GENERAL MOTORS CORP.
  1. Locate the intake camshaft position actuator to the camshaft and loosely install the bolt.
    2. NOTE: Refer to Torque Reaction Against Timing Drive Chain Notice .
    IMPORTANT: Use an open-end wrench at the camshaft hex to prevent camshaft/engine rotation.
  2. Tighten the camshaft position actuator bolt. Refer to Camshaft Position Actuator Installation - Left Side Intake (Fourth Design) .
  3. Install the left exhaust camshaft actuator. Refer to Camshaft Position Actuator Replacement - Bank 2 (Left Side) Exhaust (First Design)  or Camshaft Position Actuator Replacement - Bank 2 (Left Side) Exhaust (Fourth Design) .
scientia non olet · About LEMON Manuals