LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Engine Mechanical - 3.8L) >> Repair Instructions - On Vehicle >> Engine Support Fixture >> Procedure

Engine Support Fixture: Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (L26) .
    2. Fig 1: View Of J-28467-501 & J 28467-B Cross Bar Installed On Engine
    GM815195Courtesy of GENERAL MOTORS CORP.
  2. Remove the left engine mount strut and the bracket from the upper radiator support. Refer to Engine Mount Strut Bracket Replacement - Upper Radiator Support .
  3. Assemble the J-28467-501  (2) to the J 28467-B  cross bar (1).
  4. Install the J 28467-B  (1) and the J-28467-501  (2) to the fender rails.
    5. Fig 2: Identifying J 36462-A & Cross Bar
    GM815198Courtesy of GENERAL MOTORS CORP.
  5. Install the J 36462-A  (1) to the cross bar (2). See Special Tools .
    6. Fig 3: View Of Support Lift Hook & Cross Bar
    GM1251282Courtesy of GENERAL MOTORS CORP.
  6. Install the support lift hook (2) to the cross bar (1).
  7. Install the support hook (1) to the right engine lift hook (3).
    8. Fig 4: Identifying Support Hook, J 36462-A & Left Engine Lift Hook
    GM815211Courtesy of GENERAL MOTORS CORP.
  8. Install the support hook (1) to the J 36462-A  (2). See Special Tools .
  9. Install the support hook (1) to the left engine lift hook (3).
    10. Fig 5: Releasing Pressure Off Of Engine Mounts
    GM815216Courtesy of GENERAL MOTORS CORP.
  10. Raise the engine to release the pressure off of the engine mounts.
scientia non olet · About LEMON Manuals